Advertisement
DEVIreg™ 528
▪ Place the floor sensor in a conduit in an appropriate
place where it is not exposed to sunlight or draft from
door openings.
▪ Equally distant and >2cm from two heating cables.
▪ The conduit should be flush with the floor surface -
countersink the conduit if necessary.
▪ Route the conduit to the connection box.
▪ The bending radius of the conduit must be min 50mm.
Follow the steps below to mount the thermostat:
1. Open the thermostat:
▪ Press the release tab in the bottom of the thermostat
using a screwdriver or similar object.
▪ Carefully detach the front cover.
▪ Carefully detach the frame.
Installation Guide
2
40
50
30
20
3
4
5
6
7
Hide quick links:
Advertisement
