Devireg 535
Setting up your Devireg 535 programmable thermostat with
your devimat system
Select the oor
To change the default setting, press
l and use the arrow buttons to
select your choices. Press l to accept
your choice.
Press for the next setting.
Maximum oor temperature.
- Tiles on timber based oor = 29°C
- Tiles on concrete based oor = 40°C
- Timber covered oors = 27°C
(parquet etc. - Please check with
oor supplier).
To change this setting, press l and
use the arrow buttons to select
your choice. Press l to accept your
choice.
Press for the next setting.
Scale
When selecting Celsius, the display
will show the actual temperature at
the oor sensor.
To change this setting, press l and
use the arrow buttons to select
your choice.
Press l to accept your choice.
The installation procedure is now nished.
You can use the for going back or forward through
the settings, otherwise:
Press the installation pinhole to exit
installation mode.
Put the frame and front back on.
Selection of sensor type
Power on the thermostat
With the front o , with
a small screwdriver
or pencil press the
installation button.
sensor
You enter the settings by pressing the
pencil, the display now changes from
temperature to time display.
Setting the time
By pressing the l, the hours starts
ashing - you can now change them
with the .
Press the l again to change the
minutes with the .
To nish, press l then
Setting the weekday
Mon Tue Wed Thu
By pressing the l, the weekday starts
ashing - you can now change them
with the .
Press the l to accept.
To nish press
pinhole with a small screw driver,
Fri
Sat
Sun