Installation Of Compressor - Toyota HILUX 1993 Repair Manual

AC–22
AIR CONDITIONING SYSTEM
3. INSTALL PRESSURE PLATE
(a) Put the shims to the pressure plate.
(b) Using SST and torque wrench, install the shaft
Torque: 14 N–m (140 kgf@crm, 10 ft–lbf)
4. CHECK CLEARANCE OF MAGNETIC CLUTCH
Check the clearance between the pressure plate and rotor
using thickness gauge.
Standard clearance:
If the clearance is not within tolerance, change the number
of shims to obtain the standard clearance.

INSTALLATION OF COMPRESSOR

(See page
1. INSTALL COMPRESSOR WITH THREE MOUNTING
BOLTS
Torque: 27 N@m (280 kgf@cm, 20 ft@Ibf )
2. INSTALL DRIVE BELT
(See step 2 and 3 and on page AC–14)
3. CONNECT TWO HOSES TO COMPRESSOR SERVICE
VALVES
Torque: Discharge line 25 N@m (250 kgf@cm, 18 ft@Ibf )
4. CONNECT CLUTCH LEAD WIRE TO WIRING HARNESS
5. CONNECT NEGATIVE CABLE TO BATTERY
6. EVACUATE AIR FROM AIR CONDITIONING SYSTEM
7. CHARGE AIR CONDITIONING SYSTEM WITH
REFRIGERANT AND CHECK FOR GAS LEAKAGE
Specified amount: 700 – 800 g (1.5 – 1.8 Ib)
– Compressor
bolt. SST 07112–76060
0.5" 0.15 mm (0.020 i 0.0059 in.)
AC–17 )
Suction line 25 N@m (250 kgf@cm, 18 ft@lbf)