Seat Belts Testing; Manual Type - Toyota HILUX 1993 Repair Manual

BODY – Seat Belt
SEAT BELT
[Emergency Locking Retractor (ELR) Type]
1. RUNNING TEST (IN SAFETY AREA)
(a) Fasten the seat belt.
(b) Drive the car at 10 mph116 km/h) and make a very
hard stop.
(c) Check that the seat belt is locked and cannot be ex–
tended at this time.
HINT: Conduct this test in safe area. If the belt does not
lock, remove the belt mechanism assembly and conduct
the following static check. Also, whenever installing a
new belt assembly, verify the proper operation before in–
stallation.
2. STATIC TEST
(a) Remove the locking retractor assembly.
(b) Tilt the retractor slowly.
(e) Verify that the belt can be pulled out at a tilt of 15
degrees or less, and cannot be pulled out at over 45
degrees of tilt.
If a problem is found, replace the assembly.
CENTER SEAT BELT

(Manual Type)

TESTING
(a) Adjust the belt to the proper length.
(b) Apply a firm load to the belt.
(c) Verify that the belt does not extend.
BO–45