Toyota HILUX 1993 Repair Manual page 1228

BE–80
BODY ELECTRICAL SYSTEM
Parts Inspection
1. INSPECT SWITCHES
(Main Switch/Continuity)
Switch position
OFF
If continuity is not as specified, replace the switch.
(Cruise Control Switch /Continuity)
If continuity is not as specified, replace the switch.
(Cruise Control Switch/Resistance)
Measure the resistance value between terminals 2/5 and
4I5 or 2I2.
OFF
RESUME/ACCEL
SET/COAST
CANCEL
If resistance value is not as specified, replace the switch.
(Vacuum Switch /Operation)
(a) Check that there is continuity between terminals
(b) Check that there is no continuity between terminals
If operation is not as specified, replace the switch.
(Stop Light Switch /Continuity)
Inspect the switch continuity between terminals.
Switch pin free
(Brake pedal depressed)
Switch pin pushed in
(Brake pedal released)
If continuity is not as specified, replace the switch.
– Cruise Control System
Terminal
Terminal
Condition
Constant
Switch position
with no vacuum.
with a vacuum of 170
in. Hg, 22.66 4. 00 kPa ) or above.
Terminals
Switch position
RESISTANCE (/)
No continuity
Approx. 68
Approx. 198
Approx. 418
30mmHg (6.69 1.18