Humminbird SOLIX Operation Manual page 61

Adjust the Depth Range and Colors
NOTE: Humminbird must be selected as the map source to enable this feature.
1. From the Humminbird Settings menu, select the settings shown in the table below.
Depth Colors Turn on Depth Colors and adjust the range for depth shading in the Chart Views.
Turn on Depth Highlight to highlight a depth setting in the Chart Views. The depth you set will be
Depth Highlight
highlighted in green. Use Depth Highlight with Highlight Range.
When a Depth Highlight is active in the Chart Views, use Highlight Range to highlight a range on each
side of the highlighted depth. For example, if you know a certain fish is holding at 18 to 20 feet, you
Highlight Range
can set the Depth Highlight at 19 feet, and the Highlight Range a +/– 1 foot. The view will show a green
band from 18 to 20 feet.
Turn on Shallow Water and adjust the slider. When the depth is equal to or less than the amount set,
Shallow Water it will be highlighted in red in the Chart Views. For example, if your boat has a draft of 3 feet, set the
Shallow Water menu to 3 feet, and the unit will draw a red band from 0 to 3 feet.
Turn on Contour Interval to display lines at set intervals on the Chart View. Adjust the slider to set the
Contour Interval distance between each line. Contour Interval is also affected by the Water Level Offset setting. See
Map Source: Set up Humminbird.
61
depth colors
depth highlight
contour interval
Chart Options