Mounting The Camera Using The Hard Ceiling Mount - Illustra Flex 2MP PTZ 20x Indoor Quick Start Manual

Mounting the camera using the Hard Ceiling Mount

Follow the steps below to install the camera using the hard ceiling mount.
Mounting the camera using the hard ceiling mount
Step Action
1 Mark the positions of the three screw holes on the hard ceiling mount at the chosen installation location.
2 In the marked locations, drill each hole slightly smaller than the supplied Screw Anchors, and put
supplied anchors into these drilled holes. Then faster the hard ceiling mount with the three self-tapping
screws.
3 Thread the data cable and the ethernet cable through the center hole of the mount and connect the cable
to the camera body.
4 Install the camera on the fixed hard ceiling mount by turning the camera clockwise. Then tighten the
screw at the side of the fixing plate.
5 After installing the camera on the hard ceiling mount, put the dome cover back on. Then fasten the
screw on the side of the dome cover.
6
Figure 6 Hard Ceiling Mount
- End -
Illustra Flex 2MP PTZ Quick Start Guide