Table of Contents
Advertisement
Installing Edge Guide
The edge guide allows for a pre-set
amount of material to be removed from
the workpiece with each pass.
Note: Use the edge guide only with the
1" and 1
⁄
" rubber drums and sanding
1
2
sleeves.
To install edge guide:
1. Align holes in edge guide with holes in
base plate, and attach guide using (2)
plastic knobs (see Figure 9).
Plastic Knobs
Edge Guide
Figure 9. Edge guide components.
2. Place a straightedge across edge
guide faces and sanding drum, and
adjust the position of edge guide until
straightedge touches drum (see Figure
10).
Model T27961 (Mfd. Since 02/17)
Edge Guide Face
Base Plate
Figure 10. Aligning edge guide faces with
sanding drum.
3. Tighten left knob to hold edge guide in
place.
4. Set guide in or out for amount of
material you want to remove, then
tighten right knob (see Figure 9).
Note: Trial and error will be required to
achieve the desired amount of material
removal. We recommend testing the edge
guide on a scrap piece similar to the actual
workpiece. Always check guide adjustment
after changing sanding drums.
-15
-
Advertisement
Table of Contents
