Grizzly T27961 Owner's Manual page 10

The following is a list of items shipped
with your tool. Before beginning setup, lay
these items out and inventory them.
If any non-proprietary parts are missing
(e.g. a nut or a washer), we will gladly
replace them; or for the sake of expediency,
replacements can be obtained at your
local hardware store.
If you cannot find an item on this
list, carefully check around/inside
the tool and packaging materials.
Often, these items get lost in pack-
aging materials while unpacking or
they are pre-installed at the factory.
A
G
J
K
-10
-
Inventory
B
F
E
L
Figure 1. Inventory.
Inventory (Figure 1)
A. Table Mounting Pad ...........................1
B. L-Shaped Anchor Bolts ......................2
C. Wing Nuts M8-1.25 ............................2
D. Sander ...............................................1
E. Fender Washer 13mm .......................1
F. Clips ...................................................2
G. Fender Washer 6mm .........................1
H. Rubber Drums
I. Guide Plate ........................................1
J. Dust Port 1
K. Cap Screw M6-1 x 12 ........................1
L. Sanding Sleeves
⁄ ", ⁄ ", 1", 1
1 3
2 4
M. Plastic Knobs M5-.8 x 18 ...................2
N. Hex Wrench 5mm ..............................1
C
I
H
M
Model T27961 (Mfd. Since 02/17)
⁄ ",1", 1 ⁄ " .......... 1 Ea.
3 1
4 2
⁄ ".....................................1
1
2
⁄ " ............................ 1 Ea.
1
2
D
N