Figure 10: The Scanning Screen - Codan 2110 Reference Manual

If the transmit and receive frequencies are the same, the frequency is only displayed in
the receive frequency position on the right side of the screen and the Rx indicator arrow
is not used. The signal strength/output power indicator shows whether the transceiver is
receiving or transmitting.
Your transceiver has the option of selecting high or low power by pressing Tx PWR.
When low power is selected, Lo is displayed to the right of the signal strength indicator
(see
While a call is being established, the transceiver will show that calling activity is in
progress by flashing CALL in place of the scan indicator (see
this indicator is replaced with an icon showing the type of call being sent or received (see
Figure
When the transceiver is scanning, the channel screen is replaced by the scanning screen
(see

Figure 10: The scanning screen

2110 SSB Transceiver Reference Manual
Figure 9). When high power is selected, Hi is displayed in this location.
9). These icons are listed in
Figure 10).
Table 17 on page 158
scan indicator
Operating the transceiver
Figure 10). During a call,
and Table 18 on page 166.
49