Codan 2110 Reference Manual page 19

This term
call detect time
channel
Channel Test call
counterpoise
Emergency call
frequency
Get Position call
Get Status call
Group Selective call
front panel
hot key
Last Heard Log
2110 SSB Transceiver Reference Manual
Means...
The length of time during scanning that the transceiver pauses
on each channel in order to detect an incoming call. It is the
inverse of the scan rate.
Frequencies programmed in the transceiver to transmit and
receive signals on air.
A call that enables you to test the quality of a channel. It is
sometimes referred to as a Beacon call. If you have the MIL-
STD-188-141B ALE option installed, Channel Test calls may be
made in an ALE/CALM network to replace information in the
LQA database, and to perform a manual sounding operation.
A radial array or a grid network of metallic wires arranged
horizontally around the base of an antenna to provide an
effective earth plane.
A call that enables you to trigger an emergency alert tone at a
specific station then speak to an operator there.
The number of cycles per second of a radio wave, usually
expressed in kilohertz.
A call that gets the GPS position of a specific station.
A call that gets diagnostic information about the transceiver at a
specific station.
An ALE call that is sent to stations specifically addressed in the
call that are tuned to the same frequency in an ALE/CALM
network or scanning the network.
The Group Selective call may be used in Emergency, Message,
Phone, Selective, and Send Position calls if the MIL-STD-188-
141B ALE option is installed.
The interface that is used to control the functions of the
2110 SSB Transceiver. It consists of a display, keypad and
connectors for the handset, antenna and earthing.
A key on the front panel that is pre-programmed with a macro
that enables you to perform a task quickly.
A log of the last 100 on-air transmissions detected by the current
station. The information gathered from each transmission
includes the self address of the heard station, the time/date of the
transmission, and the channel/mode used for the transmission.
The Last Heard Log is available if the MIL-STD-188-141B
ALE option is installed.
About this manual
7