Advertisement
3
A
-
REMOVE THE LOWER DRAWER
1
2
Press the release tabs
in on either side and
push back to release
drawer from runners.
Lift drawer off runners.
3
3
OPTIONALLY HARD WIRING PRIOR TO INSTALLATION
To prevent kinked hoses
Either sit the drawer down on the left
hand side (recommended) or rotate the
drawer clockwise, resting it on its side after
removal.
3
4
Push drawer
runners back in
on either side.
Sit the drawer down
3
4
Push drawer
runners back in
on either side.
Rotate the drawer
clockwise (max. 90
o
)
and rest on side.
3
B
-
REMOVE THE ACCESS COVER & REMOVE POWER
1
Clip
Access cover
1
With a flat-bladed screwdriver, push
in the clips and slide out the access
cover.
2
Unscrew the electronics module
cover.
3
Carefully pull out the electronics
module and rest on the chassis base
out of the way.
4
With a screwdriver, unclip the plastic
harness cover and hinge open.
5
Slide the terminal block cover
sideways to unlock and hinge open
to access the terminal block.
6
Unscrew the Live, Neutral and Earth
wires as shown.
7
Unscrew the three screws on the
base as shown and remove the cord
from the product.
1
Clip
5
4
Remove existing
power cord
7
6
7
3
2
Electronics
module
Terminal
Block cover
Advertisement
