Omnik Omniksol-10k-TL3 User Manual page 21

2. According to the marks, drill 4 holes in the wall. Then place four expansion tubes in
the holes using a rubber hammer. Next make 4 screws through the mounting holes in
the bracket, and then tighten the screws into the expansion tubes. So far, the wall
mounting bracket is fixed already.
3. Check the 4 holes in the backside of the inverter. Then lift the inverter carefully, align
the 4 holes in the inverter and the 4 hooks on the bracket, and finally attach the
inverter to the hooks slightly.
19