Algo 3006 Installation Manual
Algo 3006 Installation Manual

Algo 3006 Installation Manual

Trunk port doorphone

Advertisement

Quick Links

DC300600-05
Jul 02, 2002.
3006 Trunk Port Doorphone Installation Guide

ABOUT THE 3006 DOORPHONE

The Algo Doorphone Model 3006 consists of a control unit (3005), a door station
(3004) and a power supply (3242). All options and controls are factory set to allow
for a quick installation of simple wire connections.

QUICK INSTALL

STEP 1
Run a two-pair cable from the door station location to the control unit location
(equipment room). A recessed double-gang utility box is ideal for mounting the
door station. The door station can be located anywhere a speakerphone or talkback
paging would be considered. The door station should be mounted at shoulder
height.
STEP 2
Connect the door station as per the wiring diagram on page 4. Use this wiring
configuration as a standard so that all installations are similar. Mount the door
station, dressing all wires neatly.
STEP 3
Wall mount the control unit as near as possible to an AC outlet. Connect the door
station wires as per the attached drawing.
STEP 4
Connect the control unit terminals (T & R) to a CO line or trunk circuit of the
telephone system. The control unit will also work with single line telephones.
STEP 5
Connect the power adapter into the rear of the circuit unit cabinet and plug into an
AC outlet.
STEP 6
Test the unit by pushing the call button of the door station. The control unit initiates
ringing into the telephone system. Answer the "call" and ensure that a voice path is
established with the door station.
NOTE:
The Doorphone is factory set to ring five times and then abandon the
call. This may be changed by setting the "ring persist" option switches.
P. 1
Algo Communication Products Ltd. 4500 Beedie Street, Burnaby, B.C. Canada V5J 5L2
Tel: (604) 438-3333 Fax: (604) 437-5726
www.algosolutions.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 3006 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Algo 3006

  • Page 1 3006 Trunk Port Doorphone Installation Guide ABOUT THE 3006 DOORPHONE The Algo Doorphone Model 3006 consists of a control unit (3005), a door station (3004) and a power supply (3242). All options and controls are factory set to allow for a quick installation of simple wire connections.
  • Page 2 O O O O O O X Six rings O O O O O O O No limit POSITON: Ring Voltage Auxiliary Relay Algo Communication Products Ltd. 4500 Beedie Street, Burnaby, B.C. Canada V5J 5L2 Tel: (604) 438-3333 Fax: (604) 437-5726 www.algosolutions.com...
  • Page 3 8 of SWITCH-2 to OFF. AUXILIARY JACK This jack provides power and signal lines to operate the Algo Model 3106 Door Control Module. Do NOT use this jack for anything else. The 3106 Door Control Module will provide a dry contact closure to operate a customer-supplied door latch.

Table of Contents