Paper Tray Fails To Close; Printing Takes Too Long; Printer Fails To Print - Xerox Phaser 3330 User Manual

Probable Causes
Incorrect setting

Paper Tray Fails to Close

Probable Cause
The paper tray does not close fully.

Printing Takes Too Long

Probable Causes
The printer is set to a slower printing mode. For
example, the printer could be set to print on
Heavyweight paper.
The printer is in Power Saver mode.
The way the printer was installed on the net-
work could be an issue.
The job is complex.
The print-quality mode in the driver is set to
Enhanced.

Printer Fails to Print

Probable Causes
The printer has an error.
The printer is out of paper.
A toner cartridge is empty.
® ®
Xerox Phaser 3330 Printer
User Guide
Solutions
In the print driver Properties, select 2-Sided
Print on the Paper/Output tab.
Solution
Some debris or an object is blocking the tray.
Solutions
It takes more time to print on certain types of
special paper. Ensure that the paper type is set
properly in the driver and at the printer control
panel.
It takes time for printing to start when the
printer is exiting of Power Saver mode.
Determine if a print spooler or a computer
sharing the printer is buffering all print jobs and
then spooling them to the printer. Spooling can
slow print speeds. To test the speed of the
printer, print some information pages such as
the Office Demo Page. If the page prints at the
rated speed of the printer, you could have a
network or printer installation issue. For addi-
tional help, contact the system administrator.
Wait. No action needed.
Change the print-quality mode in the print
driver to Standard.
Solutions
To clear the error, follow the onscreen prompts.
If the error persists, contact your Xerox representative.
Load paper into the tray.
Replace the empty toner cartridge.
Troubleshooting
7-3