Storage Battery - Benelli Tornado TNT600 Owner's Manual

STORAGE BATTERY

When the storage battery is used for the first time, please operate based on the steps below:
Remove the vent gum cap, fill the storage battery electrolyte into the position between upper
limit (UPPER) and lower limit (LOWER), stand for 30 minutes and use after the chemical reaction
is complete. Please check if the electrolyte level is between the upper limit and lower limit
before using. Make sure to use electrolyte provided.
When the new storage battery is used for the first time, it should be initially charged after
filling electrolyte. This should be operated by the distributors.
Please connect the wire poles correctly, positive lead (red wire) must be connected to the
positive terminal( + ) while negative lead (black wire) to negative terminal( - ), and tighten the
terminal bolt. Please use the wire brush to clear away the corrosive substances on the terminal
frequently.
The storage battery should be installed steadily and the vent line should be installed properly
to ensure the vent line is connected to the vent of storage battery.
53