Adjustment Of Idling Speed - Benelli Tornado TNT600 Owner's Manual

ADJUSTMENT OF IDLING SPEED

The engine should be at normal operation temperature to accurately adjust the idling speed.
1. Place the motorcycle aat vertical position and start the engine to heat-up.
2. Use the throttle stop screw to adjust the idling speed to 1400-1600r/min
Turn the adjusting screw clockwise to the decrease the rotating speed, while screw the
adjusting screw counter clockwise to increase the rotating speed. Please do not over-
screw the adjusting screw counter clockwise, otherwise the idling speed will decrease
instead and be unstable.
3. Please cut off the engine after adjustment, and restart after three 3 seconds, after two
minutes' stable operation, please confirm the idling running again.
Start the engine to warm up it during the idling. After that, close the accelerator and
adjust the idling screw knob to keep the rotating speed of engine in the lowest stable
level (between 1400-1600r/min). The idling screw is located at the right side of connecting
port between throttle valve and air filter.
38