Wilson Electronics 814001 Installation Manual page 3

4. AMPLIFIER INSTALLATION (see illustration on pg.4)
4.1 Installing the
Wilson Cellular
4.1.1 See antenna packaging for model specific instructions.
WARNING:
Verify that both the outside antenna and adapter extension cable are con-
nected before powering up the AMPLIFIER.
RF SAFETY WARNING: (MOBILE ONLY)
with a separation distance of at least 15.5 inches from any of the vehicle
occupants or nearby persons and must not be co-located or operating
in conjunction with any other antenna or amplifier. Use of a cellular
amplifier with antenna gains higher than 5.12dBi is in violation of FCC
regulations for which the offender is fully liable. All Wilson Mobile
Antennas are 5.12dBi or less.
WARNING: (IN-BUILDING ONLY)
ing installations.
RF SAFETY WARNING: (IN-BUILDING ONLY)
antenna must be fixed-mounted on an outdoor permanent structure with a
separation of at least 20 feet from all persons during normal operation.
4.2 Installing The Amplifier
4.2.1 Select a suitable location to mount the AMPLIFIER.
• In vehicle installation - under the dash or vehicle seat
• In building installation - on a wall or ceiling
NOTE: Mount the AMPLIFIER away from direct sunlight, excessive heat and/or mois-
ture. The amplifier needs proper ventilation. DO NOT place the amplifier in
an air-tight enclosure. Use #6 screws to mount the amplifier.
4.2.2 Connect the outside antenna to the AMPLIFIER side labeled "OUTSIDE
ANTENNA".
4.2.3 Connect the ADAPTER EXTENSION CABLE to the AMPLIFIER side
labeled "CELLULAR PHONE".
4.2.4 An external antenna adapter is required (sold separately) to connect the
AMPLIFIER to the cellphone. External antenna adapters connect directly to
the antenna extension cable.
4.2.5 Connect the DC power supply to the AMPLIFIER. Verify that both the
OUTSIDE ANTENNA and the ADAPTER EXTENSION CABLE are
connected before powering up the AMPLIFIER.
NOTE: Visit our website at
Antenna
The outside antenna must be mounted
Lightning protection is recommended for all in-build-
www.wilsonelectronics.com
3
When using in-building, the outside
for the latest adapter cross