Replacing The Desiccant Bag - Motorola VC70N0 Quick Reference Manual

VC70N_QRG_72-164687-01_English_October 16.fm Page 23 Tuesday, October 16, 2012 2:29 PM
Quick Reference Guide
• Service door - provides access to the micro USB On-The-Go for
ActiveSync without the need to disconnect any accessory, access to
the Micro SD card slot and access to the desiccant.
• Access to the On/Off switch (the door can be removed without
affecting the sealing).
• Access to the backup battery.
For general cleaning:
• Clean the casing, keyboard, and display window by wiping with a soft
cloth. Use a damp cloth if necessary.
• Never use solvents or abrasive cleaners. You may damage the
display or keyboard.

Replacing the Desiccant Bag

The VC70 ships with a desiccant bag installed. The installer may wish
1.
to replace the desiccant in the VC70 with a new bag prior to installing
the VC70 on the vehicle, as transit and storage may have saturated
the desiccant.
Open the two screws securing the service door and remove the door.
2.
Pull out the old dessicant bag.
3.
Open the new desiccant package and remove the desiccant bag.
4.
Fold the four corners of the bag under to form a pillow.
5.
Place the desiccant bag in the desiccant well.
6.
Carefully place the service door onto the right side of the housing.
7.
Be sure to torque the screws to seal the device properly.
CAUTION
Otherwise, sealing can be compromised.
Torque the torx head screws to 4.0 + 10% kgf-cm (3.5 ± 10% lbs-in).
8.
Desiccant Well
Desiccant Bag
Service Door
23