Starting And Stopping The System; Starting The System - JRC JCY-1850 Instruction Manual

1. Operation

1.3 Starting and Stopping the System

1.3.1 Starting the System

ATTENTION
To operate the Recording Control Unit, the front door has to be unlocked and
opened.
To turn on the equipment, after all units are connected, follow the procedure described below.
1. Starting the Recording Control Unit
1) Unlock the front door with the key and open it.
2) Turn on the Power Supply Unit.
3) Then the POWER LED on the Power Supply Unit lights up.
4) The CARD LED on the Main Control Board (MCB) lights up.
5) The REC LED on the Main Control Board (MCB) lights up.
2. Starting the Operation Panel Unit
The Power Supply Unit in the Recording Control Unit supplies power to the Operation Panel
Unit.
1) When the Power Supply Unit in the Recording Control Unit is turned on, the POWER LED
on the Operation Panel Unit lights up simultaneously.
2) T he Recording LED on the Operation Panel Unit lights up after several seconds.
3. Start the Protective Capsule Unit
The Power Supply Unit in the Recording Control Unit supplies power to the Protective
Capsule Unit. When the Power Supply Unit in the Recording Control Unit is turned on, the
Protective Capsule Unit is activated simultaneously.
4. Starting the Microphone Unit
The Audio Recording Board in the Recording Control Unit supplies power to the Microphone
Unit. When the Power Supply Unit in the Recording Control Unit is turned on, the Microphone
Unit is activated simultaneously.
5. Starting the Option Unit
The option unit means Radar Interface Unit. The Recording Control Unit supplies AC power
to the option unit. When the Recording Control Unit is on, the option unit is also turned on.
The power switch of option unit should always be set to ON.
5.1 Radar Interface Unit
Set the POWER SWITCH on the front panel to ON.
4