Actions To Be Taken At The Time Of An Accident (Guidelines) - JRC JCY-1850 Instruction Manual

1. Operation
5) Take out the CF CARD. Insert the card with a CARD ADAPTER into the PC that has a
PCMCIA slot and copy the data into the PC.
6) After the copy has been finished, insert the CF CARD into the CARD slot on the Main
Control Board. (Be sure that the JRC-label side is pointing right on the CF CARD.)
7) Make sure that the CARD LED lights up.
ATTENTION
When the CARD LED is left turned off for 10 minutes or more, the MEDIA
LED lights up on the Main Control Board and the Operation Panel Unit gives
the alarm with ALARM BUZZER. ALARM lamp and ERROR CODE LEDs will
be blinking. (Error Code: 31__) If a CF CARD is inserted into the CARD slot
in the Main Control Board, the ALARM BUZZER stops and ALARM LEDs will
be off.
ATTENTION
If the backup to CF CARD is likely to be made frequently, purchase of one
more card is recommended. (CF Card code: 7HRJD0002)

1.4.4 Actions to be taken at the time of an accident (Guidelines)

When a marine accident occurs, it is necessary to store the record data of hull and
navigation information at that time.
This section shows some guidelines of how to preserve the data.
The actions to be taken at the time of accident depend primarily on how serious the
accident is in the guideline here of some solutions are shown, but the final judgment has
to be made by captain himself. ie. Whether the accident is serious or not has to be
judged by captain persi.
After careful check of the situation of the accident, preserve the data.
The authority requires the submission of the preserved data. If you are not sure how to
do, contact the Sales Department of Japan Radio Co., Ltd.
Case1: Carrying on the voyage is possible as the accident is not serious...
Step. Actions
Stop recording data onto the CF CARD
1
when voyage is stopped by the accident.
Take out the CF CARD.
2
Copy the recorded data from CF CARD
3
to HDD of PC.
Check the copied data.
(Each folder name shows the date and
time when the data was recorded)
Return the CF CARD to RCU after
4
copying
Operation of RCU
Press the CARD STOP SWITCH.
Make sure that the CF CARD LED
is turned off.
Press the CARD EJECT BUTTON.
Make sure that the CARD LED
lights up.
8
Ref.
Section
1.4.3
Section
1.4.3
Section
1.4.3
Section
1.4.3