JRC JCY-1850 Instruction Manual page 37

Table 8: ERROR code table of the Operation Panel Unit (2/3)
ALARM DETAIL
SYSYTEM CODE
3 0
3 1
3 2
3 3
3 4
3 5
3 6
3 7
3 8
4 0
4 1
4 2
5 1
:
9
* *
6 0
* *
6 1
CATEGORY
MCB MCB Initialize error
An abnormality has been detected in the Main Control Board.
CF CARD alarm
Ten minutes or more has passed since the CF CARD was
taken out.
CF CARD media error
The CF CARD does not record data correctly.
Time adjustment error
Time data is not received from GPS, therefore the internal
clock of S-VDR cannot be calibrated.
RTC error
An internal lithium battery for a Real Time Clock IC has run
out of the life.
EEPROM check sum error
An abnormal data has been detected in configuration data
registered on the EEPROM of the MCB.
EEPROM access error
The access to the EEPROM IC on the MCB, where setup data
are registered.
Flash ROM check sum error
An abnormal data has been detected in configuration data
registered on the Flash ROM of the MCB.
Wrong data registered to MCB
The value registered to the configuration data of the EEPROM
on MCB is not correct.
ARB ARB Initialize error
An abnormality has been detected in the Audio Recording
Board on the MCB.
ARB control error
The MCB did not fetch the audio data from the ARB
successfully.
ARB error
The ARB did not compress/decompress the audio signal
successfully.
MIC MIC test error
An abnormality has been detected during the microphone
checkups carried out at the startup of the equipment and
every 12 hours during the operation. The second digit (1-9)
identifies the Microphone Unit out of order.
Serial data Serial data (IEC61162-1/2 ) reception error
The input received from the sensor is not normal.
(NMEA)
"**" identifies the sensor that has sent the unreadable data.
Refer to table 9.
Serial data (IEC61162-1/2 ) setup error
The setup to receive NMEA serial data is in the wrong.
"**" identifies the equipment. Refer to table 9.
CONTENTS
23
1. Operation