Table of Contents
Advertisement
E 2000 Nordson Corporation
All rights reserved
c. Tighten the screws again and recheck the chain tension.
Continue this process until tension/deflection matches the
dimensions shown in Figure B 2-5 when all four speed reducer
screws are tight. Tighten the screws to 6.78–8.14 NSm (5–6 ft-lb).
Lock the chain-tensioning screw nut.
d. Recheck the speed reducer sprocket. Make sure the sprocket is
level with the drive shaft sprocket.
4.1–5.8 mm
(0.16–1.23 in.)
2.0–2.9 mm
(0.08–0.12 in.)
Fig. B 2-5
Chain Tension/Deflection
1. Chain-tensioning screw
7. Reinstall the hopper and drive covers.
8. Restore the system to normal operation.
41-3000
Issued 11/00
2
1
2.0–2.9 mm
(0.08–0.12 in.)
2. Tight chain
B 2-17
Pump
4130914A
B2EN-02-[3-PUMP]-5
Hide quick links:
Advertisement
Table of Contents
