Table of Contents
Advertisement
S
S
UPER
ERVER 5037MC-H12TRF User's Manual
5-6
Installing Memory
Caution! Exercise extreme care when installing or removing DIMM modules to prevent
any possible damage to the DIMMs or their sockets
How to Install Memory
1. Insert the desired number of DIMMs into the memory slots in the following
order: DIMMA2, then DIMMB2, DIMMA1, DIMMB1. Pay attention to the notch
along the bottom of the module to prevent incorrect installation.
2. Insert each DIMM module vertically push down until it and snaps into place.
Repeat to install more memory, if needed. See instructions on the next page.
Memory Support
Each X9SCE-F supports up to 32GB of Unbuffered ECC DDR3-1600/1333/1066
memory in four DIMM slots. Only VLP (Very Low Profi le) DIMMs are supported.
Please refer to the product page on our web site for possible updates to memory
support.
Note: BIOS rev. 2.0 is needed to support new E3-1200 v2 CPUs, which support
PCI-E 3.0 and DDR3 1600 MHz memory.
Figure 5-3. Installing and Removing DIMMs
5-6
DIMMA1
DIMMA2
DIMMB1
DIMMB2
Advertisement
Table of Contents
