Supero MicroCloud User Manual page 57

VGA Enable/Disable (JPG1)
JPG1 allows the user to enable the
onboard VGA connector (through the
KVM). Close pins 1~2 to enable the
VGA. The default setting is Enabled.
Watch Dog RST/NMI Selection
(JWD1)
Watch Dog (JWD1) is a system moni-
tor that can reboot the system when a
software application hangs. Close pins
1~2 to reset the system if an applica-
tion hangs. Close pins 2~3 to generate
a non-maskable interrupt signal for
the application that hangs. See the
table on the right for jumper settings.
Watch Dog must also be enabled in
the BIOS.
2
SMB (I C) Bus to PCI Slots (JI2C1/
JI2C2)
2 2
Jumpers JI C1 and JI C2 allow you to
connect the System Management Bus
(SMB) to the PCI-E slots. The default
setting is set to Disabled. See the
table on the right for jumper settings.
BMC Enable/Disable (JPB1)
Jumper JPB1 allows you to enable the
embedded BMC (Baseboard Manage-
ment Controller) to provide IPMI 2.O/
KVM support on the motherboard.
See the table on the right for jumper
settings.
Chapter 5: Advanced Motherboard Setup
VGA Enable/Disable
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Open
2
I
Jumper Settings
Jumper
On
Off
Jumper Settings
Pin#
1-2
2-3
5-15
Defi nition
Enabled
Disabled
Watch Dog
Defi nition
Reset
NMI
Disabled
C to PCI-Slots
Defi nition
Enabled
Disabled (Default)
BMC Enable
Defi nition
Enabled (default)
Disabled