Elcometer 204 User Manual page 5

4 GETTING STARTED (continued)
All dual element transducers which can be connected directly to the
base of the gauge - see Section 10.1 'Transducers' on page en-8 - are
'intelligent' transducers. The transducer frequency and diameter will
be identified automatically by the gauge.
Details of the transducer connected can be viewed at any time via
Menu/About/Transducer Information.
A transducer adaptor is available which enables other Elcometer
'non-intelligent', dual element transducers and other manufacturers'
transducers, to be used with the gauge - see Section 10.4 'Transducer
Adaptor' on page en-11.
4.3 SELECTING YOUR LANGUAGE
1 Press and hold the ON/OFF button until the Elcometer logo is
displayed.
2 Press Menu/Setup/Language and select your language using the
  softkeys.
3 Follow the on screen menus.
To access the language menu when in a foreign language:
1 Switch the gauge OFF.
2 Press and hold the left softkey and switch the gauge ON.
3 Select your language using the
4.4 SCREEN SETTINGS
A number of screen settings can be defined by the user via
Menu/Setup/Screen Settings including:
Screen Brightness; This can be set to 'Manual' or 'Auto' - the

brightness is adjusted automatically using the gauge's ambient
light sensor.
Screen Timeout; The display will dim if inactive for more than

15 seconds and will go 'black' if inactive for the period defined.
Press any key or tap the gauge to awaken it. The gauge can
also be set to switch off automatically after a user defined
period of inactivity via Menu/Setup/Gauge Auto Off. The
default setting is 5 minutes.
www.elcometer.com
 
softkeys.
R
en-4