Processor - HP ProLiant ML110 G7 Maintenance And Service Manual

Install the heatsink, and then insert and tighten the four screws.
4.
Install the power connector.
5.
Connect the fan cable to the fan connector on the system board.
6.
Install the air baffle
7.
Install the access panel
8.
Install and lock the front bezel
9.
Power on the server.
10.

Processor

CAUTION:
• Handle the processor only by the edges.
• Do not touch the bottom of the processor, especially the contact area.
IMPORTANT:
installing the processor.
To remove the processor:
Power off the server
1.
Unlock and remove the front bezel.
2.
Remove the access panel
3.
Remove the heatsink.
4.
CAUTION:
seating during installation, leading to hardware damage.
("Installing the air baffle" on page 27).
("Installing the access
("Installing the front
To avoid damage to the processor:
If installing a processor with a faster speed, update the system ROM before
("Power down the server" on page 23).
("Removing the front
("Removing the access
Failure to completely open the processor locking lever prevents the processor from
panel" on page 24).
bezel" on page 25).
bezel" on page 25)
panel" on page 24).
Removal and replacement procedures 59