Retaining The Recovery Key/Password - HP ProLiant ML110 G7 Maintenance And Service Manual

Install the TPM board. Press down on the connector to seat the board.
6.
Install the TPM security rivet by pressing the rivet firmly into the system board.
7.
Install the system fan.
8.
Install the access panel
9.
Install the bezel
10.
Power up the server.
11.

Retaining the recovery key/password

The recovery key/password is generated during BitLocker™ setup, and can be saved and printed after
BitLocker™ is enabled. When using BitLocker™, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker™ detects a possible compromise of system
integrity.
To help ensure maximum security, observe the following guidelines when retaining the recovery
key/password:
•
Always store the recovery key/password in multiple locations.
("Installing the access
("Installing the front bezel" on page 25).
panel" on page 24).
Removal and replacement procedures 56