Remove Front Housing Remote Mount Version Models Only; Remove The Top Cover Low Power Models; Mid Power Models; Removing The Top Cover - Low Power Models - Motorola MCS 2000 Service Instructions Manual

!
C a u t i o n
Remove Front
Housing
R M
EMOTE OUNT
V M O
ERSION ODELS NLY
Remove the Top
Cover
L P M
OW OWER ODELS
M P M
ID OWER ODELS
5-2 Disassembly & Reassembly and Replacement Procedures
The control head must be removed before removing the transceiver top
cover.
4. Pull the control head off of the transceiver while pressing the snaps. (Go
to "Remove the Top Cover" section below).
1. Disconnect the Remote Mount Cable by squeezing the top and bottom
of the connector together, disengaging the bottom snap then the top
and pulling straight out.
2. Insert a small flat-blade screwdriver or like instrument in the side groove
at the interface between the remote front housing and the transceiver
(see Figure 5-1). Press while pulling the housing away from the
transceiver until the snap releases. Repeat the operation on the opposite
side.
3. Remove the 18 position connector from the front of the transceiver.
4. Pull housing off the transceiver.
1. Pry the cover free from the chassis by inserting a small flat-blade
screwdriver or like instrument into the area shown in Figure 5-2 and
rotating the handle of the screwdriver over the top of the radio. This will
disengage the snap between the cover and chassis. Rotate the cover away
from the chassis and pull off. (Go to "Remove the Cavity Shield"
paragraph, page 5-3).
Figure 5-2 Removing the Top Cover - Low Power Models
1. Insert a wide flat-blade screwdriver or like instrument in the recess area
on the side of the radio near the RF and DC connector end (see Figure 5-
3).
2. Pry the cover off the chassis by pushing the handle of the screwdriver up
and toward the radio. This will disengage the snap between the cover
and chassis.
Disengage Snap Here