Assembly Of Control Head To Transceiver Dash Mount Models; Remote Mount Models - Motorola MCS 2000 Service Instructions Manual

!
C a u t i o n
Assembly of Control Head to Transceiver
D M M
ASH OUNT ODELS
R M M
EMOTE OUNT ODELS
driver (see Figure 5-7). Install the remaining screws (except the three
screws that retain the PA shield) with 6-8 in lbs of torque using a T-10
Torx driver.
9. On Mid Power Models Only: Install the PCB and Audio PA clips.
10. Insert the PA shield. Tighten the three screws that hold it to the PCB and
the one screw in the middle of the board with 6-8 in lbs of torque using a
T-10 Torx driver.
11. On Low Power Models: Install the Cavity Shield and press down until it
locks on the chassis tabs.
Ensure that ALL cavity shield tabs engage properly. Failure to do this may
inhibit the top cover from engaging properly and could damage the top
cover.
12. Place a new cover gasket around the chassis ensuring that it is placed
under the locking tabs and ledge at the front of the chassis. To ensure
that the gasket remains seated along the groove, twist the gasket between
fingers down and toward the chassis on both sides of the chassis.
13. Install the top cover by engaging the hooks on front of the chassis and
rotating the cover back. Ensure that the side snaps on the cover are
engaged.
14. Install the front cover gasket over the front of the transceiver ensuring
that the rectangular hole in the transceiver aligns with the rectangular
hole in the gasket. Press the gasket flush against the transceiver to ensure
proper sealing.
1. For Model I: Install dash mount configured control head onto the
transceiver. Ensure that the side snaps are engaged.
For Models II and III: Install the retention frame over the front of the
transceiver. Install the dash mount configured control head onto the
transceiver. Slide the retention frame toward the control head until both
snaps engage.
1. Install the 18 position connector into the female connector (mounted
on the PC board) through the hole in the front of the chassis.
2. Install the remote header retainer into the recess for the rectangular
cutout in the remote front housing.
3. Install the remote front housing over the 18 position connector onto the
front of the transceiver ensuring that both snaps are engaged.
4. Connect the remote mount cable to the transceiver and to the remote
mount configured control head.
Disassembly & Reassembly and Replacement Procedures 5-15