Display Example - Alarm Setting - KYORITSU KEW6024PV Instruction Manual

.800.561.8187
11-3 Display example – Alarm setting
Insulation measurement
(stand-by state)
Alarm mark and the pre-set reference value are displayed while alarm function is
enabled. When starting a PV insulation or earth resistance measurement, the
alarm mark will only be displayed.
Insulation measurement
(during measurement)
When ">" has been selected, buzzer sounds and blinking ">" mark
and the pre-set reference value are displayed when the measured
value exceeds the reference value.
When "<" is selected at setting, buzzer sounds and blinking "<" mark
and the pre-set reference value are displayed when the measured
value is less than the reference value.
Indications remain the same at PV insulation measurement. Buzzer
sounds when the measured value is greater or lower than the
pre-set reference value.
www.
Fig. 11-8
Fig. 11-10
- 48 -
̶ 48 ̶
.com
Earth measurement
(stand-by state)
Fig. 11-9
Earth measurement
(during measurement)
Fig. 11-11
information@itm.com