Charge Handset And Battery - ASCOM Myco SH1 User Manual

User Manual
Ascom Myco SH1 Wi-Fi and Cellular Smartphone
2 When the handset displays: "No messaging number configured for this device", press
"Setup number".
3 When the handset displays: "enter messaging number", that is, the phone number of
the handset, enter the number.
4 Press "Done".
If the unite system is configured for User log in, enter user log in and password, supplied by
the system administrator.
TIP: If a wrong number is entered, a factory reset must be done, and all handset
configuration parameter settings are restored to default values. Refer to Configuration
Manual.
4.4

Charge Handset and Battery

The handset has a rechargeable lithium-ion battery. To charge, use either the Charging Rack,
or the Micro USB cable.
NOTE: To show the Charging screen, the handset must be switched On. This applies to both
the Charging Rack, and the Micro USB cable.
4.4.1 Charge with Charging Rack
NOTE: A handset can be configured to be cleared of messages and alerts when placed in a
Charging Rack. Contact your system administrator for desired setting.
1 Place the handset in a Charging Rack slot. The charging screen appears as soon as the
handset is correctly inserted, and shows the current charge level. Allow the handset
to charge fully. It takes approximately four hours with a fully depleted battery.
The handset is fully charged, and ready to use, when the charging screen shows
100%, and the color-coded LED priority beacon is fixed green.
TIP: It is recommended to always charge the battery fully to extend the battery life,
although there's no harm made to the handset, when removed from the Rack Charger
earlier than 100% accessed battery power.
2 To remove it from the Charging Rack, lean the handset forward slightly and pull.
4.4.2 Charge with Micro USB cable
WARNING: It is recommended to use the Micro USB cable, together with desired (EU/US) USB
Power supply available. To use a non-tested, or budget USB charger can cause serious injury,
or death.
1 Carefully open the USB charging connector cover on the bottom of the handset.
2 Attach the Micro USB cable into the micro USB slot on the handset.
3 Assemble the Micro USB cable and the USB Power supply.
TIP: You can use the separate Micro USB cable on a computer USB port (disassemble
the Micro USB cable from the USB Power supply by pressing the button on the back of
the USB Power supply, and pull). Note that the battery may drain instead of charge, if
the handset is connected to a computer that's switched off, or is in sleep or standby
mode.
4 Connect the handset, using the assembled Micro USB cable, and USB Power supply, to
a power outlet.
5 Allow the handset to charge fully. It takes approximately four hours with a fully
depleted battery.
2 April 2015 / Ver. A
4. Getting Started
TD 93066EN
14