Getting Started; Quick Steps For System Administrators; Insert Sim Card; Easy Deployment - ASCOM Myco SH1 User Manual

Wi-fi and cellular
Table of Contents

Advertisement

User Manual
Ascom Myco SH1 Wi-Fi and Cellular Smartphone
4.

Getting Started

The following chapter describes how to start using the handset. Read it through, before
using the handset for the first time.
4.1

Quick Steps for System Administrators:

Perform the following steps to get the handset started:
NOTE: Remove the protective plastic sheet that is attached to the display at delivery, before
using the touchscreen to ensure proper function.
1
Insert the Micro-SIM (for the Cellular version only). Refer to
page 13.
2
Close the battery cover, and lock it.
NOTE: If desired, change the language. Enter the handset ID (Easy deployment). If not
already done as prerequisite, perform Easy deployment. Refer to the Configuration
Manual.
3
If desired, configure parameter settings for the site, or user. Refer to the
Configuration Manual.
4.2

Insert SIM Card

NOTE: Cellular only.
1
If needed, unlock the battery cover, and remove it.
2
The SIM card slot is located under the clip. Press on the clip to open it fully, and insert
the Micro-SIM in the SIM card slot, in the direction as shown on the label.
TIP: If needed, use a tweezer to hold it, then push it into the slot.
3
Close the battery cover, and lock it. The handset starts within seconds if the battery is
charged.
TIP: If the handset does not start, charge the battery, and then long press the Power
button to switch the handset On.
4.2.1
Remove SIM Card
1
Open the battery cover lock. Press on the clip to open it fully, and remove the Battery
Pack.
2
Remove the SIM card by using a 3-4 mm screwdriver, or similar tool, in the hole above
the SIM card slot, and pull outwards, until the SIM card can be removed (with your
fingers, or a tweezer).
NOTE: Be careful not to damage the inside of the SIM card slot.
4.3

Easy Deployment

A handset is automatically installed and configured, if the VoWiFi system is configured for
Easy Deployment. Refer to the Configuration Manual.
If the VoWiFi system is not automatically installed and configured, do as follows.
1
If the handset is switched On, switch it Off and then On again.
2 April 2015 / Ver. A
4. Getting Started
TD 93066EN
4.2 Insert SIM Card
on
13

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Myco SH1 and is the answer not in the manual?

Questions and answers

Table of Contents