Using Usb Devices - Canon LBP6670dn Series Service Manual

2
Technology > MEAP > Maintenance > Using USB Devices

■ Using USB Devices

● USB Driver
Two types of USB drivers
While the USB driver that can be used in iR series is only the USB driver designed exclusively
for MEAP application (hereinafter referred to as "MEAP driver"), not only MEAP driver but
also USB system driver (hereinafter referred to as "system driver") can be used in iR-ADV
series.
System driver and MEAP driver cannot be used together. When either of them is used, the
other driver cannot be used.
In this model, the USB system driver supports only Mass Storage; HID is not supported. In
other words, storage devices such as USB Flash memory can be used via system driver, but
interface devices such as USB keyboard cannot be used via system driver.
● USB driver setting
System driver is active by default in iR-ADV series.
The driver can be changed in setup menu.
Usually, It is not necessary to change the setting because it is specified in the MEAP
application side.
Only in the case of a special MEAP application, it is necessary to change the USB driver
setting.
For details, refer to specifications of MEAP application side.
Setup
Interface
Network
Interface Selection
Layout
Timeout
Quality
Connection Recog.
Interface
Extended RX Buffer
USB Storage Device
MEAP Driver
2 Technology > MEAP > Maintenance > Using USB Devices
Interface Selection
USB
Network
USB Storage Device
MEAP Driver
Off
On
F-2-127
USB Storage Device Application that supports mass storage
Settings: [ MEAP Driver ]
ON Can use USB mass storage device. Can
* MEAP driver (compatibility work only on the applications that support
mode) the MEAP application driver.
OFF (*default) Cannot use USB mass storage device.
* Native driver (Device cannot be detected.)
Note:
When any settings changes are made, the device must be restarted.
2-57
MEAP application that
device supports system driver
Cannot use USB mass
storage device.
Can use USB mass
storage device.
2-57
T-2-18