Installing An Eps-500 External Power Supply Unit; Rack-Mounting An Eps-500 Power Supply - Extreme Networks Summit X150 Series Hardware Installation Manual

Hide thumbs Also See for Summit X150 Series:
Table of Contents

Advertisement

Installing an EPS-500 External Power Supply Unit

You can position the EPS-500 facing either the front or the back of the rack. For this reason, each unit
has two sets of mounting holes on each side. Extreme Networks recommends that you position the
EPS-500 unit so that the power output connectors of the EPS-500 unit are on the same side as the
external connector on the connecting switch.
The EPS-500 unit can be mounted in a rack or placed free-standing on a table.
NOTE
An AC power cord is not provided with the EPS-500 unit. See
Switches and AC Power Supplies" on page 500

Rack-mounting an EPS-500 Power Supply

CAUTION
When you install an EPS-500 in an equipment rack, make sure that the air vents are not restricted.
Allow for elevated ambient operating temperatures when the unit is installed adjacent to other equipment. To avoid
hazardous conditions due to uneven mechanical loading, make sure that the equipment is mounted properly in the
equipment rack.
Do not use the rack-mount brackets to suspend the EPS-500 from under a table or desk, or to attach the unit
to a wall.
To rack-mount each EPS-500:
1 Place the EPS-500 upright on a stable surface, with the side you want to face to the front of the
switch toward you.
2 Remove the mounting bracket kit from the packaging.
3 Attach the mounting brackets as follows:
a Place a mounting bracket over the mounting holes on one side of the EPS-500 (see
b Insert the provided screws and fully tighten the screws using a screwdriver.
Figure 250: Attaching a Mounting Bracket
c Repeat steps
a
and
4 Slide the EPS-500 into a 19-inch rack and secure it using appropriate rack-mount screws.
Summit Family Switches Hardware Installation Guide
for information about selecting a power cord.
b
on the opposite side of the EPS-500.

Installing an EPS-500 External Power Supply Unit

"Power Cord Requirements for AC-Powered
Collin's
ES4K026
XM_073
Figure
250).
309

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents