Versatile Interface Modules For The Summit X480 Series Switches; Vim2-10G4X Versatile Interface Module - Extreme Networks Summit X150 Series Hardware Installation Manual

Chapter 3: Summit Option Cards and Versatile Interface Modules
Versatile Interface Modules for the Summit X480
Series Switches
A VIM2 or VIM3 versatile interface module can be installed in a dedicated slot at the back of the
Summit X480 series switch to provide high speed stacking ports or 10-Gbps Ethernet ports. Summit
X480 series switches support the following modules:
VIM2-10G4X module (this page)
●
VIM2-SummitStack module
●
VIM2-SummitStack128 module
●
VIM2-SummitStack-V80 module
●
VIM3-40G4X module
●

VIM2-10G4X Versatile Interface Module

The VIM2-10G4X versatile interface module
modules. For information about the supported optical modules, refer to the most recent version of the
ExtremeXOS Hardware and Software Compatibility Matrix
Figure 125: VIM2-10G4X Versatile Interface Module
XFP ports
S1
S2
LEDs
The XFP ports are labeled S1, S2, S3, and S4. ExtremeXOS software assigns port numbers to the XFP
ports based on the switch model in which the VIM2-10G4X module is installed (see
Table 56: Port Numbers for XFP Ports on the VIM2-10G4X Module
Summit X480-48t or
Port Summit X480-48x
Label Port Number
S1 49
S2 50
S3 51
S4 51
Ports S3 and S4 can be used as alternate stacking ports in a SummitStack configuration that uses the
SummitStack-V feature. For more information about stacking Summit family switches, see
166
(page 167)
(page 167)
(page 167)
(page 168)
(Figure
S3
S4
SH_152
Summit X480-24t
Port Number
27
28
29
30
125) provides four 10-Gbps ports using XFP optical
Summit Family Switches Hardware Installation Guide
Table 56).
Chapter 5.