Installation; Installing The Module Rear Plate; Figure 2-1: 7800Fr Rear Panel With Cover Plate Installed - evertz 7800 Manual

7800 MultiFrame Manual
7800FC VistaLINK Frame Controller
®
2.

INSTALLATION

The 7800FC Frame Controller module can only be installed into 7700FR-C, 7800FR and 7800FR-QT
frames that have been fitted with the proper module interconnect circuit board. These frames have an 'L'
shaped cover plate installed, adjacent to the IEC power inlet connector as shown in Figure 2-1. If your
frame does not have this L shaped cover plate then the 7800FC Frame controller card cannot be installed
in this frame.
2.1.

INSTALLING THE MODULE REAR PLATE

Page-2

Figure 2-1: 7800FR Rear Panel with Cover Plate Installed

The 7800FC rear panel kit consists of a screw and lock
washer, and two sub-assemblies, the 7700CM-2
connector module and the 7800FC rear panel plate
which houses the appropriate connectors for the module.
To install the 7800FC rear panel kit, locate slot 1 at the
right side of the frame's rear panel. Remove the filler
plates from the slot as shown in step 1 of Figure 2-2.
Install the 7700CM-2 subassembly first. Remove the
screw PART 1 as shown in Step 2. Carefully align the
7700CM-2 socket with the frame header and press firmly
into place as shown in step 3. Secure the 7700CM-2
sub-assembly with the M2.5x16 mm screw and M2.5
lock washer as shown in Step 4.
Orient the 7800FC plate so that the labeling is visible
when the plate is installed (see Step 5). Loosely fasten
the plate to the extrusions using the mounting screws
you removed in Step 1. You will tighten the screws after
the main module is installed.
Revision 1.0