Dot-Matrix Display - evertz 7800 Manual

7800 MultiFrame Manual
7800FC VistaLINK Frame Controller
®
4.2.

DOT-MATRIX DISPLAY

Additional signal status monitoring of the card's parameters is provided via the 4-character alphanumeric
status display located on the card edge.
When the card is initially inserted, it will display the message BOOT and then the message EXEC. This
indicates that the 7800FC is running through its bootup sequence and executing the application code.
Once the application code is completely loaded and ready to use, it will display the message FC.
If the shaft encoder is pressed in, the display will cycle through the firmware version and the IP address of
the 7800FC.
Page-11
Revision 1.0