Trap Setup; Snmp V3 Setup - evertz 7800 Manual

7800 MultiFrame Manual
7800FC VistaLINK Frame Controller
®
For example:
**** SNMP Setup ****
<1> Read Community String
<2> Read/Write Community String
<3> Trap Setup
<X> Exit
>

6.2.2.3. Trap Setup

"Trap Setup" allows the user to define IP addresses of the trap listeners for when the asynchronous
fault messages are sent. A maximum of ten IP addresses can be stored in the Frame Controller. After
selecting "Add..." or "Remove..." IP addresses are entered one at a time.
Add Trap
Add a SNMP trap server IP address to the TRAP distribution list.
Destinations
Remove a SNMP trap server IP address from the TRAP distribution list. For
example, selecting this option reveals the list of IP addresses with the prompt to
Remove Trap
remove one from the list:
Destinations
Displays a list of all entered SNMP trap server IP addresses. For example:
Show All Trap
Destinations
Once the SNMP V1 Setup parameters have been configured, exit the SNMP Setup by pressing X then
<Enter>.

6.2.2.4. SNMP V3 Setup

In SNMP V3 Setup menu, there are two submenus to choose from:
SNMP V3
User Setup
SNMP V3
Trap Setup
Once the SNMP V3 Setup parameters have been configured, exit SNMP V3 Setup by pressing X then
<Enter>.
Page-18
Trap #1: 192.168.1.76
Trap #2: 192.168.8.140
Remove trap # > 2
Trap #1: 192.168.1.76
Trap #2: 192.168.8.140
Trap #3: 192.168.8.112
This menu item is used to set User configuration parameters including Add, Edit,
Remove and Show users
This menu item is used to set Trap configuration parameters including Add,
Remove, and Show traps
[public]
[private]
Revision 1.0