Network Setup - evertz 7800 Manual

To choose one of the menu choices, enter the letter or number shown on the left and then press <Enter>.
If you choose menu item 1 or 2 or 3 you will be presented with an additional menu. Choose menu items
on these sub menus in the same way or press X to return to the main menu.

6.2.1. Network Setup

The Network Setup menu has six network parameters that need to be configured. If the network is using a
DHCP server, set the DHCP parameter to yes before proceeding to change the other parameters. When
the DHCP setting is set to yes, the IP Address, Netmask, Gateway, and Broadcast addresses are
automatically assigned and their corresponding menu items are disabled.
If the network is not using a DHCP server, set the DHCP parameter to No before proceeding to change the
IP Address, Netmask, Gateway, and Broadcast addresses.
The following screen displays the network settings on the 7800FC frame controller.
**** Network Setup ****
(1) Use DHCP [N]
(2) Hostname [fc-default]
(3) IP Address [192.168.1.187]
(4) Netmask [255.255.255.0]
(5) Gateway [192.168.1.1]
(6) Broadcast [192.168.1.255]
(7) Use Telnet [N]
(X) Exit
>
The DHCP mode should be disabled before proceeding with the 7800FC Frame
Controller upgrade, which is outlined in section 7.3.7. In order to successfully

upgrade the device, select No [N] when prompted for DHCP mode, as shown in
the above network setup screen. If the DHCP is enabled you will be unable to
proceed further with the upgrade. See section 7.3.7 for instructions on upgrading
the 7800FC Frame Controller.
The chart below gives a brief description of each menu item and what the parameter does. To choose one
of the menu choices, enter the letter or number shown on the left and then press <Enter>. You will be
prompted to enter the required parameter value. When you are done configuring the Network Setup menu
items press X to return to the main menu. If you are unclear about how to configure your network, consult
your network administrator.
7800FC VistaLINK
Revision 1.0
7800 MultiFrame Manual
Frame Controller
®
Page-15