Exiting The Setup Menu - evertz 7800 Manual

7800 MultiFrame Manual
7800FC VistaLINK Frame Controller
®
6.2.2.4.2. SNMP V3 Trap Setup
The SNMP V3 Trap Setup menu allows the user to define IP addresses of the trap listeners for when
the asynchronous fault messages are sent. A maximum of ten IP addresses can be stored in the
Frame Controller. The different between SNMP V1 Trap and SNMP v3 Trap is that SNMP V3 requires a
matching User, which is created in the previous section.
Add New V3
Trap Destination
Remove V3 Trap
Destination
Show All
SnmpV3 Trap
Destinations
Once the SNMP V3 Trap Setup parameters have been configured, exit SNMP V3 Trap Setup by pressing
X then <Enter>.

6.2.3. Exiting the Setup Menu

From the Main Menu, press X to save the configuration to memory. After 30 seconds, a successful save of
the configuration is acknowledged with a "Commit successful" statement, and the user is returned to the
"login" prompt.
For example: (after pressing X<enter>)
**** Main Menu ****
<1> Network Setup
<2> SNMP Setup
<X> Exit
<W> Exit without saving to flash
X
Please wait 30 seconds to save settings to flash...
Commit successful.
NetBSD/evertz <fc-default>
login:
Press W if you made an error during configuration and want to exit the setup menu without saving the new
settings. In either case you will return to the "login:" prompt.
Page-20
Add Trap destination such that Frame Controller will send fault messages to
specified address.
Enter Trap Destination
Address
Enter Trap Destination User
Note: If user is deleted after trap information is created, this trap information is not
valid and Frame Controller will not send fault message to that IP address.
Removes previously entered trap information.
Lists all entered trap information. It will show destination IP address and trap
User.
Enter IP address all at once
Enter User Name only. Input is required to match
one of Users created in previous section
Revision 1.0