Configuring The Network Settings - evertz 7800 Manual

7800 MultiFrame Manual
7800FC VistaLINK Frame Controller
®
2.
Install the 7800FC card into the frame. After the card powers up and the boot-up messages are
finished, a "login" prompt will appear in the terminal window.
software version information is displayed prior to the "login" prompt and should be quoted to Service
staff when required.)
For example:
Kernel Build Date
Software
Tag
Software Build Date : Jan 30, 2013
Wed Jan 30 11:05:46 GMT 2013
NetBSD/evbppc (780xfc) (console)
login:
3. If the prompt does not appear, the following is a list of possible reasons for failed communications:
•
Defective Serial Upgrade cable.
•
Wrong communications port selected in the terminal program.
•
Improper port settings in the terminal program. (Refer to step 1 for settings).
4.
At the "login" prompt, enter:
•
"customer" for user name <Enter>
•
"customer" for password <Enter>

NOTE - Neither username nor password can be modified at the time of this manual
revision release.
5.
A menu for Network, SNMP and FC Upgrade Setup Configuration appears and is detailed in the
next section.
6.2.

CONFIGURING THE NETWORK SETTINGS

From main menu, three selections are available - Network Setup, SNMP Setup.
•
Network Setup is used to set network IP addresses as well as broadcasting and routing instructions
•
SNMP Setup is used to identify up to ten trap destination IP addresses.
**** Main Menu ****
<1> Network Setup
<2> SNMP Setup
<X> Exit
<W> Exit without saving to flash
>
Page-14
: Jan 28, 2013
: v1.2 Build 2
: 7801FC_r1-2-2
Revision 1.0
(For future reference 7800FC