Gpi/O Connections; Serial I/O Connections; Replacing The Battery; Figure 2-4: Crossover Cable Wiring Diagram - evertz 7800 Manual

If you are building a "crossover" cable you must wire it according to Figure 2-4:

2.3.2. GPI/O Connections

GP I/O: A 9 pin female 'D' connector for connection to external devices. (Currenlty this port is not used.)

2.3.3. Serial I/O Connections

SERIAL I/O: A 9 pin female 'D' connector for connection to a computer. (Currently this port is not used.)
Pin #
1
2
3
4
5
6
7
8
9
2.4.

REPLACING THE BATTERY

The Frame Controller is fitted with a 3V Lithium battery type CR2032. This battery is used to power non-
volatile memory of some of the frame controller's parameters while power is removed from the frame.
Before attempting to change the battery remove power from the 7800FC card.

Figure 2-4: Crossover Cable Wiring Diagram

Name
GND Chassis ground
Tx RS-232 Transmit Output
Rx RS-232 Receive Input
Sig Gnd RS-232 Signal Ground
RTS RS-232 RTS Input
CTS RS-232 CTS Output

Table 2-2: Serial I/O Connector Pin Definitions

Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
7800FC VistaLINK
Description
CAUTION
Revision 1.0
7800 MultiFrame Manual
Frame Controller
®
Page-7