Invacare® TDX® SP2 Series
9.6 Removing/Installing the Shrouds
CAUTION!
– Place the wheelchair in a well ventilated area
where work can be performed without risking
damage to carpeting or floor covering.
Fig. 9-1 Removing/Installing the
Rear Shroud
Fig. 9-3 Hooks on the Wheelchair
Frame
70
Fig. 9-2 Removing/Installing the
Front Shroud
Fig. 9-4 Front Shroud Detail
9.6.1 Removing the Rear Shroud
1. Verify the joystick On/Off switch is in the Off position.
2. Remove the knob screw A that secures the rear shroud
B to the base frame C.
3. Remove the rear shroud from the base frame.
9.6.2 Installing the Rear Shroud
1. Install the rear shroud B and secure in place with knob
screw A.
9.6.3 Removing/Installing the Front Shroud/Battery
Retention Bracket
Removing
The front shroud/battery retention bracket C is removed
from and installed onto the wheelchair frame D as a single
unit.
Front shroud/battery retention bracket C mounts on hooks
E located on the wheelchair frame D.
Have the following tools available: 1/4 inch Allen
Wrench, 7/16 inch Box Wrench.
1. Remove the mounting screws F securing the front
shroud/battery retention bracket to the wheelchair
frame D.
2. Lift up to unhook the front shroud/battery retention
bracket from the base frame and remove.
Installing
60101831-A