Stability Lock; Removing/Installing The Shrouds; Removing The Rear Shroud; Installing The Rear Shroud - Invacare TDX SP User Manual

1. Use the following instructions to clean this product unless
otherwise specified.
•
Upholstery — Warm water and mild non-abrasive soap.
•
Metal — Hot water and mild non-abrasive soap. Car polish
and soft wax may be used to remove abrasions and restore
gloss.
•
Plastic — Hot water and mild non-abrasive soap.
2. Dry the surface with dry cloth.
3. DO NOT use solvents or kitchen cleaners.

8.7 Stability Lock

DANGER!
Risk of Death or Serious Injury
Not performing periodic maintenance on stability lock
could result in death or serious injury.
– ALWAYS perform the periodic maintenance to the
stability lock listed in the inspection checklist of this
manual.
1143190-N-03

8.8 Removing/Installing the Shrouds

8.8.1 Removing the Rear Shroud

1. Verify the joystick On/Off switch is in the Off position.
Remove the three mounting screw A securing the rear shroud
2.
B to the wheelchair.
Remove the rear shroud from the wheelchair D.
3.

8.8.2 Installing the Rear Shroud

Install the rear shroud B and secure in place with mounting
1.
screw(s) A.
New Batteries MUST be fully charged before using,
otherwise the life of the battery(ies) will be reduced.
Setup and Maintenance
61