Assigning An Interface To A Vrf; Assigning A Front-End Port To A Management Vrf; View Vrf Instance Information - Dell S4048–ON Configuration Manual
Hide thumbs
Also See for S4048–ON:
- Configuration manual (1039 pages) ,
- Deployment manual (78 pages) ,
- Troubleshooting manual (29 pages)
Table of Contents
Advertisement
Assigning an Interface to a VRF
You must enter the ip vrf forwarding command before you configure the IP address or any other setting on an interface.
NOTE:
You can configure an IP address or subnet on a physical or VLAN interface that overlaps the same IP address or subnet
configured on another interface only if the interfaces are assigned to different VRFs. If two interfaces are assigned to the same
VRF, you cannot configure overlapping IP subnets or the same IP address on them.
•
Assign an interface to a VRF instance.
INTERFACE
ip vrf forwarding vrf-name
Assigning a Front-end Port to a Management VRF
Starting in 9.7(0.0) release, you can assign a front-end port to a management VRF and make the port to act as a host interface.
NOTE:
You cannot assign loop-back and port-channel interfaces to a management port.
To assign a front-end port to a management VRF, perform the following steps:
1
Enter the front-end interface that you want to assign to a management interface.
CONFIGURATION
interface tengigabitethernet 1/1
2
Assign the interface to management VRF.
INTERFACE CONFIGURATION
ip vrf forwarding management
Before assigning a front-end port to a management VRF, ensure that no IP address is configured on the interface.
3
Assign an IPv4 address to the interface.
INTERFACE CONFIGURATION
ip address 10.1.1.1/24
Before assigning a front-end port to a management VRF, ensure that no IP address is configured on the interface.
4
Assign an IPv6 address to the interface.
INTERFACE CONFIGURATION
ipv6 address 1::1
You can also auto configure an IPv6 address using the ipv6 address autoconfig command.
View VRF Instance Information
To display information about VRF configuration, enter the show ip vrf command. To display information on all VRF instances (including
the default VRF 0), do not enter a value for vrf-name.
•
Display the interfaces assigned to a VRF instance.
EXEC
Virtual Routing and Forwarding (VRF)
1069
Advertisement
Table of Contents
Troubleshooting
