Using The Quick Setup - Pioneer VSX-D814 Operating Instructions Manual

02 5 minute guide

Using the Quick Setup

You can use the Quick Setup to get your
system up and running with just a few button
presses. The receiver automatically makes
the necessary settings after you have selected
your speaker setup, room size and listening
position.
If you want to make more specific settings,
refer to Choosing your receiver setup on
page 42.
Use the front panel controls for the steps
below.
VSX-D914 model only – Note that you don't
have to make these settings if you use the
automatic MCACC setup instead (in this
case, go straight to the Quick surround sound
setup on page 14).
SB CH
SPEAKERS MODE
VIDEO INPUT
S-VIDEO
1 If the receiver is off, press
STANDBY/ON to turn the power on.
2 Press QUICK SETUP.
SW DET flashes in the display while the
receiver checks your setup for a subwoofer.
SW YES or SW NO confirms the subwoofer
check, then the display prompts you to select
your speaker setup.
12
En
MULTI JOG
ENTER
MASTER VOLUME
MULTI JOG
TONE QUICK SETUP
DOWN
VIDEO L AUDIO R
3 Use the MULTI JOG dial to choose your
speaker setup.
When a subwoofer was detected in step 2, you
can cycle between the following choices:
7.1ch
If a subwoofer wasn't detected in step 2, you
can cycle between the following choices:
7.0ch
• Check the table below to find the speaker
setup that corresponds with your system.
UP
4 Press ENTER.
5 Use the MULTI JOG dial to choose your
room size.
Depending on the distance of your speakers
from the listening position, choose between
small, medium, or large (S, M or L), M being
an average-sized room.
2.1ch 3.1ch
6.1ch 5.1ch
2.0ch 3.0ch
6.0ch 5.0ch
4.1ch
4.0ch