Using The Quick Setup - Pioneer VSX-D912K Operating Instructions Manual

02 5 minute guide

Using the Quick Setup

You can use the Quick Setup to get your
system up and running with just a few button
presses. The receiver automatically makes
the necessary settings after you have selected
your speaker setup, room size and listening
position.
Note that you don't have to make these
settings if you use the automatic MCACC
setup instead (in this case, go straight to the
Quick surround sound setup on page 14).
If you want to make more specific settings,
refer to Choosing your receiver setup on
page 44.
Use the front panel controls for the steps
below.
ADVANCED STEREO/ SIGNAL MIDNIGHT/
SURROUND DIRECT SELECT LOUDNESS
ENING MODE
L DIMMER
DIGITAL IN
1 If the receiver is off, press
STANDBY/ON to turn the power on.
The STANDBY indicator goes out.
2 Press QUICK SETUP.
SW DET flashes in the display while the
receiver checks your setup for a subwoofer.
SW YES or SW NO confirms the subwoofer
check, then the display prompts you to select
your speaker setup.
12
En
ENTER
MASTER VOLUME
MONITOR TONE QUICK SETUP
SPEAKERS
DOWN
MULTI JOG
VIDEO INPUT
S-VIDEO VIDEO L AUDIO R
3 Use the MULTI JOG dial to choose your
speaker setup.
When a subwoofer was detected in step 2, you
can cycle between the following choices:
7.1ch
If a subwoofer wasn't detected in step 2, you
can cycle between the following choices:
7.0ch
• Check the table below to find the speaker
setup that corresponds with your system.
MULTI JOG
UP
R
4 Press ENTER.
5 Use the MULTI JOG dial to choose your
room size.
Depending on the distance of your speakers
from the listening position, choose between
small, medium, or large (S, M or L), M being
an average-sized room.
2.1ch 3.1ch
6.1ch 5.1ch
2.0ch 3.0ch
6.0ch 5.0ch
4.1ch
4.0ch