Using The Quick Setup - Pioneer VSX-D714 Operating Instructions Manual

5 minute guide

Using the Quick Setup

You can use the Quick Setup to get your
system up and running with just a few button
presses. The receiver automatically makes
the necessary settings after you have selected
your speaker setup, room size and listening
position.
Note that with the VSX-D814 you don't have to
make these settings if you use the automatic
MCACC setup instead (in this case, go
straight to the Quick surround sound setup on
page 13).
If you want to make more specific settings,
refer to Choosing your receiver setup on
page 41.
Use the front panel controls for the steps
below.
MULTI JOG
ADVANCED STEREO/ SIGNAL MIDNIGHT/ SB CH
TONE QUICK SETUP
SURROUND DIRECT SELECT LOUDNESS SPEAKERS MODE
TENING MODE VIDEO INPUT
MCACC
SETUP MIC DIGITAL IN S-VIDEO VIDEO L AUDIO R
ON
ODE
1 If the receiver is off, press
STANDBY/ON to turn the power on.
2 Press QUICK SETUP.
SW DET flashes in the display while the
receiver checks your setup for a subwoofer.
SW YES or SW NO confirms the subwoofer
check, then the display prompts you to select
your speaker setup.
3
speaker setup.
When a subwoofer was detected in step 2, you
can cycle between the following choices:
* VSX-D814 only
If a subwoofer wasn't detected in step 2, you
can cycle between the following choices:
* VSX-D814 only
MULTI JOG
ENTER
MASTER VOLUME
DOWN UP
* VSX-D814 only
Use the MULTI JOG dial to choose your
2.1ch
7.1ch*
6.1ch
2.0ch
7.0ch*
6.0ch
• Check the table below to find the speaker
setup that corresponds with your system.
3.1ch
4.1ch
5.1ch
3.0ch
4.0ch
5.0ch
02
11
En