Programming Signals From Other; Remote Controls - Pioneer VSX-D814 Operating Instructions Manual

10 Controlling the rest of your system
4 Use and
the brand name of your component then
press ENTER.
This should be the manufacturer's name (for
example, P for Pioneer).
5 Use and
turer's name from the list then press
ENTER
6 Use and
from the list, then try using this remote
control with your component.
The code should start with the component
type (for example, DVD_5305). If there is
more than one, start with the first one.
To try out the remote control, switch the
component on or off (into standby) by
pressing SOURCE
work, select the next code from the list (if
there is one).
• VSX-D914 model only – If you can't find or
properly enter a preset code, you can still
teach the remote individual commands
from another remote control (see
Programming signals from other remote
controls below).
7 If your component is controlled
successfully, press ENTER to confirm.
The remote LCD display shows OK.
Programming signals from
other remote controls
VSX-D914 model only
If the preset code for your component is not
available, or the available preset codes do not
operate correctly, you can program signals
from the remote control of another compo-
nent. This can also be used to program addi-
tional operations (buttons not covered in the
presets) after assigning a preset code.
1 While pressing the RECEIVER button,
press and hold the 1 button.
The remote LCD display shows SETUP.
58
En
to select the first letter of
to select the manufac-
to select the proper code
. If it doesn't seem to
2 Press the MULTI CONTROL button for
the component you want to control.
The LCD on the remote displays the compo-
nent you want to control.
• You can't assign the RECEIVER button.
3 Use and to select LEARN then
press ENTER.
PRES KEY and the LEARN icon show in the
LCD display.
• To exit or cancel press RECEIVER.
4 Point the two remote controls
towards each other then press the button
that will be doing the learning on this
receiver's remote control.
PRES KEY and the LEARN icon start flashing
to indicate the remote is ready to accept a
signal.
• The remote controls should be 1–2 inches
apart.
1 – 2 inches
5 Press the corresponding button on the
other remote control that is sending
(teaching) the signal to this receiver's
remote control.
For example, if you want to learn the playback
control signal, press
show OK if the operation has been learned.
If for some reasons the operation hasn't been
learned the LCD will display ERROR briefly
and then display PRES KEY again. If this
happens, keep pressing the (teaching) button
as you vary the distance between the two
remotes, until the LCD display shows OK.
. The LCD display will